GET RID OF DEAD ZONES WITH MACARD WIFI EXTENDER SETUP

Get Rid of Dead Zones with Macard WiFi Extender Setup

Get Rid of Dead Zones with Macard WiFi Extender Setup

Blog Article

Experiencing slow internet speeds in large homes is a common issue. One effective solution is the Macard WiFi Extender, designed to improve and expand your home WiFi coverage. This guide will walk you through the different methods to set up your Macard extender and enhance your network’s performance.

Macard WiFi Extender Setup: Step-by-Step Methods

You can install the Macard WiFi extender using one of the following three methods. Each is explained in detail below:

Method 1: Using the WPS Button (Simplest Option)

This is the quickest and most convenient method. It doesn’t require any cables.

Steps:


  • Place the extender near your router.

  • Plug the extender into a power outlet.

  • Turn on your existing WiFi router.

  • Press the WPS button on your router.

  • Within a few seconds, press the WPS button on the Macard extender.

  • A blinking light will appear on the extender.

  • When the light becomes solid, the connection is successfully established.


Note: After this connection, the extender adopts your router’s settings automatically. You can still log into the web interface for further customization if needed.

Method 2: Using an Ethernet Cable

This method involves a wired connection for setup.

Steps:

  1. Position the extender halfway between your router and the area with weak signal.

  2. Connect one end of an Ethernet cable to the LAN port of your router.

  3. Plug the other end into the Ethernet port of the extender.

  4. Turn on the extender.

  5. After connecting, you’ll need to finish the setup using the web interface.


Method 3: Manual Setup via Web Interface

  • If you prefer not to use WPS or Ethernet, follow these manual setup steps:

  • Plug the extender into a power outlet in the area with poor connectivity.

  • Connect a device (laptop, phone, or tablet) to the extender’s default network or use an Ethernet cable.

  • Open a web browser and enter go.macard.online or 192.168.10.1 in the address bar.

  • On the login screen, enter the default username and password (found on the extender’s label).

  • Once logged in, access the extender’s web interface.

  • Choose your existing WiFi network and enter its password.

  • Click “Connect” and wait for the extender to link to your network.


After this process, your extender is ready to use. You can also modify various settings from the web interface.

Tip: If the WPS and Ethernet methods don’t work for you, use the manual method to complete the setup.

Conclusion
By following the steps outlined above, you should be able to set up your Macard WiFi Extender without difficulty. Each method is tailored to fit different needs and setups, allowing you to expand your home WiFi with ease.

Report this page